Water repellents

AP-106 MOISTURE PROTECTOR

PACKAGES:0.75L5L20L
DESCRIPTION

Sealer, protector for the rear face of the marbles. Prevents the penetration of emerging color stainings, moisture, rust and scale. Therefore the creation of unwanted colorings on the surface of the marbles, by tannins, rust, salts and moisture is avoided. Allows the evapotranspiration within the stone but does not allow the passage of moisture. It does not affect the adhesion of the glue on the surface of the slab and therefore the adhesive performance, in accordance with the standard EN 1348. For the application of the material a single layer is required and waiting time of 24 hours. Then the slabs can be installed and bonded with marble or tile adhesive.

USED IN:
  • MARBLES
  • GRANITES
  • NATURAL STONE
  • POROUS STONES
  • LIMESTONES

TECHNICAL SPECIFICATIONS

CONSUMPTION

12 – 20 m2/L Depending on the absorbency of the surface.

Consumptions are indicative and referred to a single coating of the material.

Form: Liquid
Color: transparent
Smell: None
Density at 20°C: 1.3 g/cm3</sup
pH (at 25°C): N/A
Flash point: N/A
freezing point: 0°C
Stored at temperatures of 3°C to 30°C.

INSTRUCTIONS

The AP-106 is intended for use solely on the back side of the marbles.
After the surface is cleaned and dried the product can be applied without dilution with a brush or spray on the back side of the marbles to be affixed and to the sides. Apply only a layer. Spread evenly any liquid residues.

The slabs can be adhered the next day. In the event that the environment has too much moisture the bonding must be done after two days so as to achieve a coplete curing of the protector