Adhesives - Marble putties

SHARE

APOLLON PUTTY

PACKAGES:1L4L10L
DESCRIPTION

Thixotropic Adhesive (putty) for marble, granite, stone and limestones. It has very high adhesive strength,

medium to low viscosity for easier application on vertical surfaces and small fillings, excellent resistance in water and most chemicals while also very good weathering resistance and temperature fluctuations tolerance. The final cured product gives an excellent shine after polishing.

USED IN:
  • MARBLES
  • GRANITES
  • NATURAL STONE
  • CERAMICS & TILES
  • POROUS STONES
  • LIMESTONES
  • MOSAICS

TECHNICAL SPECIFICATIONS

Colors:  White, Beige, Gray
Viscosity (25°C): 250000-380000 mPas
Density at 20°C:  1.7 gr/cm3
Gel-time (25°C):   8 min
Glue/hardener ratio: 100/2
Flash point: 15 °C
Freezing point: -2 °C
….
Tensile strength
Tensile modulus:  5600 Mpa
Tension at break:  36 MPa
Deformation at break:  0.3 %
….
Flexural resistance
Flexular modulus:  6400 Mpa
Tension at break:  56 Mpa
 ….
Stored at temperatures from 3 °C to 30 °C.

INSTRUCTIONS

          The surface to be glued must be dry and clean. Prior mixing with the catalyst the glue may be colored with dyes to match the color of the stone. Remove the required amount of glue from the container and mix it with 2% but not more than 3% hardener. Do not return the mixed material with the hardener to the container.

Cure time 5 minutes at 25 ° C. Keep the container tightly closed in a cool place at about 20 ° C. At high temperatures the cure time is accelerated while at lower temperatures it slows down. Ensure that the application area is always sufficiently ventilated. The tools can be cleaned with alcohol or acetone