Products > Polishing - Protection > Water repellents > AP-102 OIL & WATER REPELLENT
CATEGORIES(+)

Water repellents

Security Data Sheet
SHARE

AP-102 OIL & WATER REPELLENT

PACKAGES:0,75L5L20L
DESCRIPTION

Seals and protects polished and unpolished marbles, granites and all porous stones, natural and artificial, from

oils, water, mustard stains, coffee etc. It minimizes the absorbency of the surface on water and oil without changing its color. It is very resistant to weathering and extreme weather conditions. Suitable for both indoor and outdoor applications. It is non yellowing and doesn’t create a film. The breathability through the pores of the stone is not affected and the stones are protected from the superficial cracks, salts and damage caused by frost.

USED IN:
  • MARBLES
  • GRANITES
  • NATURAL STONE
  • CERAMICS & TILES
  • POROUS STONES
  • LIMESTONES
  • CONCRETE
  • MOSAICS

TECHNICAL SPECIFICATIONS CONSUMPTION 7 – 20 m2/L Depending on the absorbency of the surface 15 – 30 m2/L On polished surfaces, according to the absorbency of the surface. All consumption rates are indicative and referred to a single coating of the material. For the protection of the treated surfaces a mild detergents such as AP-302 should be used for the daily cleaning.  

Form: Liquid
Color: Transparent
Odor: Mild
Density at 20°C: 1 gr/cm3
pH (at 25°C): 8
Flash point: 100 °C
Freezing point: -5 °C
Stored in temperatures from 3°C to 30°C.
ISO ΕΝ 16301 Determination of accidental staining(Category 1, no change)
ISO ΕΝ 1925 – Determination of water absorption coefficient through capillarity ( 98% reduction of absorption)

 

INSTRUCTIONS

Please carefully read the label. Before each use, apply the product on a small area to determine the ease of application and if you have the desired results. Make sure that the surface is clean and free of waxes or other coatings.

Make sure the application space is always sufficiently ventilated. On a well cleaned and dry surface apply the liquid undiluted with a brush or spray. Apply one or more coats by spreading any residues of liquid.

The second coating must be applied 15 minutes after the surface has dried. Any possible remaining solid residues can be removed after 30 minutes. In case that residues stay on the surface uncleaned for a longer period they can be removed with a cloth slightly soaked with the liquid.

The surface can be used after six hours, while the maximum protection is achieved after the full curing of the product. The complete curing of the product takes 24-72 hours depending on the humidity and weather conditions. The tools can be cleaned with water or with a mild detergent.